Guest
eldillo
  •  eldillo
  • 50.2% (Neutral)
  • Member Topic Starter
2011-04-30T06:27:19Z

Hello,

 

My name is David and I’m writing from Spain.

I will need a semi-professional machine to make job-labs in my home with ESXi, my option for motherboard is a Tyan 7002.

I have one provisional configuration, but I still have some doubts about hard components, Is it possible you can help me?

 

Motherboard: Tyan 7002 (S7002GM2NR-LE), link to motherboard manual  

CPU: Intel Xeon E5620 

Memory: 4x4 16GB 1066MHz ECC REG, de Ebay  

Heat sink: Noctua NH-U12P SE2 

Harddisk: 2 x Seagate ST31000528AS 1 TB (Barracuda 7200.12) 

PSU: Thermaltake Toughpower XT 875W (EPS12V 2.91)

Case: Chieftec CA-01B-B-SL (EATX)

 

My doubts are:

1. Are this hard components compatible with the motherboard Tyan 7002? and with ESXi 4.0? I wouldn’t like to have problems with the RAM.

2. Is the PSU appropiate? I select this one with standar EPS12V 2.91, but I’m not sure because the Tyan 7002 needs 24+8+8 pin, and I think PSU has only 24+8 pin.

3. Finally, this motherboard needs case with factor SSI-CEB, my selection is EATX but is quite large, Is the case EATX appropiate?

 

Thanks for your time and best regards,

David.

Sponsor
rrplay
2011-04-30T07:23:56Z

Hi and welcome !

take a look at http://forums.extremeoverclocking.com/showthread.php?t=312830

the Corsair 1000W is better choice than the Thermaltake and you will have the included cables " an 8pin to 2-4pin splitter cable with the board,"

see the comments on the  page regarding the pinning of the Corsair cables for the Corsair CMPSU-1000HX which is actually two 500w power supplies in a single enclosure.

do you have any other mainboards to consider ?

some of this may help & welcome to HH

*** Edit will need to consider the lengths of the Corsair cables as well they seem a bit short from others have mentioned elsewhere and have EATX as well that the  PSU is a bit pricey .

eldillo
  •  eldillo
  • 50.2% (Neutral)
  • Member Topic Starter
2011-04-30T09:43:03Z

Hi,

Thanks for your response, I just understand that I need a PSU with "2 x 8-pin EPS12V connector" but there are few PSUs with that specifications.

Your recomendation "Corsair CMPSU-1000HX" it's ok, but it's too many expensive.

One suggestion, what you think about this other one SilverStone OP1000 1000W? It's cheaper than other and also has 2 x 8-pin EPS12V connector (550mm)

http://www.silverstonetek.com/products/p_spec.php?pno=op1000&area=usa

 

Best regards,

rrplay
2011-04-30T10:08:35Z

yep def  agree re: Corsair and you need to mod the pins !

the SilversStone looks good thanks for searching by the way and one thing I can share with you is contact SS support email etc. and they will get back to you in a timely fashion .. maybe not on the weekend but worth the time.

they just love hearing from us anyhow.  [:)]

looks good to me &  a better choice than the Thermaltake